Victron Quattro Inverter 48/5000/70-100/100 QUA485021010

Victron Quattro Inverter 48/5000/70-100/100 QUA485021010

• Two AC inputs with integrated transfer switch
• The Quattro can be connected to two independent AC sources, for example the public grid and a generator, or two generators.
• The Quattro will automatically connect to the active source.

Two AC Outputs

• The main output has no-break functionality.
• The Quattro takes over the supply to the connected loads in the event of a
  grid failure or when shore/generator power is disconnected.
• This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
• The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge the battery, like a water heater for example, can be connected to this output.
• Split phase option A split phase AC source can be obtained by connecting our autotransformer (see data sheet on www.victronenergy.com) to a ‘European’ inverter programmed to supply 240V / 60Hz.
• Three phase capability
• Three units can be configured for three phase output. But that’s not all: up to 4 sets of three 15kVA units can be parallel connected to provide 144kW / 180kVA inverter power and 2400A charging capacity.
• PowerControl – Dealing with limited generator, shore side or grid power
• The Quattro is a very powerful battery charger. It will therefore draw a lot of current from the generator or shore side supply (16A per 5kVA Quattro at 230VAC).
• A current limit can be set on each AC input. The Quattro will then take account of other AC loads and use whatever is spare for charging, thus preventing the generator or mains supply from
  being overloaded.
• Power Assist – Boosting shore or generator power
• This feature takes the principle of Power Control to a further dimension allowing the Quattro to supplement the capacity of the alternative source.
• Where peak power is so often required only for a limited period, the Quattro will make sure that
  insufficient mains or generator power is immediately compensated for by power from the battery.
• When the load reduces, the spare power is used to recharge the battery.
• Solar energy: AC power available even during a grid failure
• The Quattro can be used in off grid as well as grid connected PV and other alternative energy systems.
• Loss of mains detection software is available.
• System configuring
•  In case of a stand-alone application, if settings have to be changed, this can be done in a matter of minutes with a DIP switch setting procedure.
• Parallel and three phase applications can be configured with VE.Bus Quick Configure and VE.Bus System
  Configurator software.
• Off grid, grid interactive and self-consumption applications, involving grid-tie inverters and/or MPPT Solar Chargers can be configured with Assistants (dedicated software for specific applications).
  On-site Monitoring and control

Several options are available: Battery Monitor, Multi Control Panel, Color Control GX or other GX devices, smartphone or tablet (Bluetooth Smart), laptop or computer (USB or RS232).
Remote Monitoring and control
Color Control GX or other GX devices.
Data can be stored and displayed on our VRM (Victron Remote Management) website, free of charge.
Remote configuring
When connected to the Ethernet, systems with a Color Control GX or other GX device can be accessed and settings can
be changed remotely.

View our Range HERE